TEGAM Forums

v1.1.54a (7227) - 11/13/2019 ------------------------------------------------------- Main Application Recompiled to change version number Analog Board No Change Web Application Added the latest user manual Removed all references to LXI Note: There are no substantive changes in this revision. TEGAM r...

v1.1.50a (7223) - 12/04/2014
-------------------------------------------------------
Main Application
Firmware changed to run from flash and not SD card

Analog Board
No Change

Web Application
No Change

Hello manickam_t - There are many reasons this issue could occur, and we will need to see some of your test files to really begin troubleshooting. Please email the following files to me at gtolentino@tegam.com: - StationConFig.xml (this is located in your root PS-Cal directory, usually C:\PS-Cal_V4\...

Hello alhudar, We've reached out to you over email several times over the past two weeks, but it appears that they have not been getting to you. I will reach out again today, to all of your email addresses that I have on file. If you do not receive that email, please email me at gtolentino@tegam.com...

PS-Cal v4.4, August 2018 Release - Add EEPROM programming support for the N1913A and N1914A power meters - Add templates for TEGAM RF standards 1505A, 2505A, 1510A, 2510A, and 1807A - Add support for Keysight U8481A, U8485A, and U8487A power sensors - Add uncertainty data for E5071C at frequencies ...

This MS Excel template includes an XML map designed to import PS-Cal's calibration results file (default location C:\PS-Cal_V4\CalResults ). There are two worksheets in the Excel workbook: Power Sensor Rho + CF: This worksheet should be used to import data for power sensors that use a cal factor. Th...

This utility may be used by PS-Cal owners to perform comparisons of current and historical power sensor calibration data. Calibration data must have been collected using PS-Cal or otherwise be in the PS-Cal-compatible data format. Download the attachment, unzip the download package, and run setup.ex...

PS-Cal v4.3, February 2018 Release - Changed bridge measurement methodology to reduce measurement time per frequency - Added amplifier support - Added samples / measurement parameter - Added dwell time parameter and set default to 13 s - Updated install package - Updated Bridge Method verification ...

Perpetual listing of changes and release notes for PS-Cal power sensor calibration automation software

Thank you for your post Tejeswar. The 4040B driver does not have a function to initiate a close session event. The 4040B is accessed through LabVIEW by opening a VISA session, and should be closed by closing that same VISA session. There’s no need to initiate that procedure through the 4040B – closi...